Microcom 466 - Manual (Page 95)

Appendix B Quick Reference Command Summary
466 Operators Manual 89
102 Allocate XX amount of blocks for PDF Memory: The remaining blocks will be
allocated to user memory.
1 (256K) 1 block
2 (512K) 5 blocks
3 (1024K) 13 blocks
4 (2048K) 29 blocks
103 User memory configuration:
0 Send the size (in bytes) of PDF Memory to serial port 1.
1 Send the size (in bytes) of total User Memory to serial port 1. Note: This is the
total size of user memory, not the size of unused User Memory, which can still
be obtained by the ^D101 command.
105 Clear fonts and graphics: (This command is currently not implemented)
0 Clear all fonts and graphics.
1-32 Clear individual fonts and graphics. The value will determine which slot is
cleared.
106 Load Font or Graphic: The ^A value determines which slot (1-255) the font or
graphic image will be stored in.
121 Set ^D122/^D123 retract/advance speed: This command sets the speed at
which the ^D122 and^D123 commands advance or retract media. The ^A value
is specified using the print speed chart.
122 Advance media: This command causes the printer to advance the media. The
amount is set using the ^A value. Note: The printer does not automatically
retract using this command. This command is used only in special applications.
123 Retract media: This command causes the printer to retract the media. The
amount is set using the ^A value. Note: The printer does not automatically
advance using this command. This command is used only in special
applications.
160 Slew speed control: If enabled, this command will cause the printer to rapidly
advance the current label when it has completed all printing.
0 Disable slew
1 Enable slew
161 RAM checksum control: If enabled, this command will cause the printer to
verify the integrity of internal user RAM. The RAM checksum is updated each
time that a file is stored in user RAM. This command should be enabled if the
printer is equipped with the battery backed RAM option.
0 Disable RAM checksumming
1 Enable RAM checksumming