Microsonic esp-4/3CDD/M18 E+S - Manual (Page 2)

2004/108/EC
Fig. 7: Connecting dbk+4 to the LCA-2
The following settings can be
undertaken:
■ Teach-in of web or label material.
■ Spacing between transmitter and
receiver.
■ NOC/NCC function of the
+U B
-U B
Colour
esp4 Colour
adapter cable
Brown
Blue
Brown
Blue
Pin
1
3
C3/Com Grey Grey 5
switched outputs.
■ Function of switched output D2.
Also available is a diagrammatic
representation of the readings.
Maintenance
No maintenance is need on the esp-
4. We would recommend cleaning
the sensor surfaces at the transmitter
and receiver should they become
very dirty. The best thing is to apply
some isopropanol onto a cotton
cloth and then wipe the surface
clean. Make sure that the reaction
time of the cleaner is kept down.
That means quickly wiping dry the
transducer surfaces.
Teach-in methods
Teach-in label dynamic
Place backing material with label between transmitter
and receiver.
Teach-in label static
a) Place only backing material between
transmitter and receiver.
Teach-in only for sheeting
(splice sensor)
Place web material between transmitter
and receiver.
Place control input C1 on logic 1 for 3 s until both LED
flash mutualy.
Pull backing material with labels among transmitter
and receiver with constant speed.
both LED flash green
simultaneously
Place control input C1 on logic 1 for 1 s.
one LED flashes green briefly,
one LED is static green
one LED is static green,
one LED flashes green
Place control input C1 on logic 1 for 6 s until
one LED turns off and one LED is on.
Pull only backing material among transmitter
and receiver.
one LED flashes green,
one LED is static green
Place control input C1 on logic 1 for 1 s.
b) Place backing material with label between
transmitter and receiver.
one LED flashes green briefly,
one LED is static green
one LED is static green,
one LED flashes green
Place control input C1 on logic 1 for 9 s until
both LEDs turn off.
Pull web material among transmitter
and receiver.
one LED flashes green briefly,
one LED is static green
Place control input C1 on logic 1 for 1 s.
one LED flashes green briefly,
one LED is static green
one LED is static green,
one LED flashes green
Normal operation
Place control input C1 on logic 1 for 1 s.
Move backing material with label between
transmitter and receiver.
one LED flashes green briefly,
one LED is static red
one LED flashes green,
one LED is static green
Place control input C1 on logic 1 for 1 s.
one LED flashes green briefly,
one LED is static green
one LED flashes green,
one LED is static green
= >