Adjusting the rack posts (optional) – Dell PowerEdge 4820 User Manual
Page 28
Advertising
26
Installation Guide
Figure 1-13.
Installing the Side Stabilizer Feet
4 Use the provided bolts, washers, and cage nuts to secure each foot to
the rack as shown in Figure 1-13.
Adjusting the Rack Posts (optional)
The position of the rack posts can be adjusted to accommodate systems
of various depths.
1 Open the rack doors.
2 Remove the screws on the bottom, middle, and top of the post
(see Figure 1-14).
3 Move the post to the desired location inside the side of the rack,
and replace the screws in the corresponding holes.
1
side stabilizer foot (2 per side)
1
Advertising
This manual is related to the following products: