Nevion Flashcase-II model 1 - Manual (Page 5)

FlashCase-II model 1 Rev. A
nevion.com | 5
2
Specifications
2.1 Ambient temperature
The equipment will meet the guaranteed performance specification under the following
environmental conditions:

Operating ambient temperature range: 0°C to +35°C

Operating relative humidity range: <90% (non-condensing)
The equipment will operate without damage under the following environmental conditions:

Temperature range: -10°C to +40°C

Relative humidity range: <95% (non-condensing
Warning: Exposure to direct sunlight during operation can result in the equivalent
ambient temperature exceeding the specified allowed maximum.
2.2 External power supplies
The external power supplies must meet the following specifications:
Voltage: Min. 10.0VDC Max. 18.0VDC
Supplied power: Min. 55W continuous
Ripple and noise: Max. 100mVpp
The product is shipped SL-PWR-90-FlashCase which is a desktop power supply for indoor
use only. For outdoor applications use power solutions suited for the current conditions.
FlasehCase II supports redundant power supply schemes by using the two power inlet.
PSU failure on one of the attached PSU is reported by GPI as well as by Multicon.
Each power inlet is protected by a a fuse. Broken fuse is reported by GPI and Multicon.
status This fuse can be changed at the internal power board. A spare fuse is mounted
close to the active fuses.
2.3 Internal voltage sources, max power
The unit has 10pcs card slots and is designed to contain up to 5pcs one card- or two card
FL-modules and combinations of such modules.
The power limitations for the internal power board are as follows:
“+5V”: Max 25W
“+15V”: Max 7.5W
“-15V”: Max 7.5W
These limits are absolute and may limit the number and combination of Flashlink modules.
2.4 GPI relays
Please keep within the following limits:
Voltage: Max +/- 30VDC between terminals
Current: Max 1A through terminals