Nevion Flashcase-II model 1 - Manual (Page 8)

FlashCase-II model 1 Rev. A
nevion.com | 8
3.7 The fiber fix board
FlashCase-II contains a board for the organization of optical components (such as CWDM
filters and splitters) and fibers.
The mounting holes is designed specifically for optical components provided by Nevion.
Use the board to organize excessive fiber lengths. This will minimize the risk of fiber damage.
The fiber clip circles have a diameter of 5cm. Make sure no fibers have a bending diameter
lower than this value.
The twin holes along the long edges are for cable ties of 2-2.5mm width.
Figure 5: Fiber fix board layout
Figure 6: Fiber fix board mounted in chassis
3.8 EMC considerations
Electrical cables should be kept away from the power board to ensure minimum noise impact
from the switching supplies.
3.9 EMC gaskets
Verify that all gaskets are properly mounted along the edge of the profile before mounting
end plates and panels with handles.