1 gpi connections – Nevion ETH-1000-SW-10G User Manual
Page 10
Advertising
ETH1000-SW-10G
Rev. E
nevion.com | 10
6.1.1 GPI connections
ETH-1000-SW-10G module GPI pinning:
Table 3: GPI pinning
Pin # Signal
Name
Mode
Pin 1 Laser off
Turn off laser.
TTL input
Pin 4 Status
General error status for the module.
Closed under normal operation.
Open if:
Power is not present on module.
Firmware is invalid.
Open Collector
Pin 5 10G link
Loss of 10G link.
Open Collector
Pin 6 Laser fail
Laser fail
Open Collector
Pin 7 +5V
+5V pin
+5V
Pin 8 Ground
0V / gnd pin.
0V.
Figure 5 GPI connector
Advertising