Nevion ETH-1000-SW-10G - Manual (Page 5)

ETH1000-SW-10G Rev. E
nevion.com | 5
2
Specifications
Due to the amount of heat generated from these units, they need to be mounted in a
frame with adequate airflow to avoid damage to the unit. On 11107 FR-2RU-10-2
external airflow support like 11131/11132 FR-FAN-1RU are recommended.
2.1 General
Power +5V DC / 11W
Control Control system for access to setup and module status
with BITE (Built-In Test Equipment)
GPI 1 in, 3 out
Temperature range 0 to +40 °C
Size 2 slot in a Flashlink chassis
2.1 Application Layer Ethernet Ports
Number of ports 5
Connector RJ45
Format IEE 802.3, 10BASE-T, 100BASE-T, 1000BASE-T
Speed Auto sensing, 10/100/1000Mbps
Cables Auto sensing, MDI/MDI-X
2.2 Network/Fiber Transport Layer
Number of ports 1
Connector Dual SC/UPC
Wavelength 850nm, 1310nm or CWDM
Optical power See relevant SFP+ datasheet
Laser type See relevant SFP+ datasheet
Extinction ratio See relevant SFP+ datasheet
Transmission circuit fiber Single mode or Multimode
2.3 Standards
Gigabit Ethernet IEE 802.3, 10BASE-T, 100BASE-T, 1000BASE-T
10 Gigabit Ethernet IEE 802.3, 10GBASE-SR, 10GBASE-LR, 10GBASE-
ER
«Jumbo» Frames Up to 10kB packet length supported.
VLAN tags IEEE_802.1ad VLAN tags pass through unmodified in
both the switch and the MUX mode.