3 interface with gyda or other controllers, Command, Response – Nevion ADC-SDI User Manual

Page 14: Comment, The “hello” command, Info, Gives back the card state, Autosearch, Set cannel search mode to automatic, Cvbsch1

Advertising
background image

ADC-SDI

Rev.

6

5.3 Interface with GYDA or other controllers

ADC-SDI follows the Flashlink-protocol, see the definition of the protocol available from our
web site:

http://www.network-electronics.com/

. ADC-SDI can also be used with any controller

or controller system that adheres to the Flashlink-protocol, using the RS422 bus. For more
information on the electrical interconnect, see the documentation of RS-2RU-10-2. The
available commands are shown in Table 6.

Command Response

Comment

?

Yes

The “Hello” command.

info

Yes

Gives back the card state.

AutoSearch

“OK”

Set Cannel Search mode to automatic.

CVBSCh1

“OK”

Set Cannel Search mode to CVBS Ch. 1.

CVBSCh2

“OK”

Set Cannel Search mode to CVBS Ch. 2.

SVideo

“OK”

Set Cannel Search mode to S-Video; Luma Ch1,
Chroma Ch2.

EDH on

“OK”

Turn on EDH in output SDI.

EDH off

“OK”

Turn off EDH in output SDI.

MarkF1 on

“OK”

Turn on the Mark Field 1-feature.

MarkF1 off

“OK”

Turn off the Mark Field 1-feature.

get [0xHH]

Yes

Get a value from a numbered register.

set [0xHH] [0xHH]

No

Set a value to a numbered register.

filter 0

“OK”

Select luma/ chroma separation filter, see Table 4.

filter 1

“OK”

Select luma/ chroma separation filter, see Table 4.

filter 2

“OK”

Select luma/ chroma separation filter, see Table 4.

filter 3

“OK”

Select luma/ chroma separation filter, see Table 4.

Table 6: All commands available to the user

5.3.1 The '?' command

According to the Flashlink-protocol, no card can use the RS422-bus before the '?' (hello)
command is sent the card at least once. The response from ADC-SDI will be:

xxxxADC-SDI\

PIC sw rev X.X.X\
FPGA sw rev X\
Protocol ver X.X

Here xxxx denotes the source and destination rack and slot coordinates, while X represents
a version number. As of primo February 2002, these revisions would be:

xxxxADC-SDI\

PIC sw rev 1.1.0\
FPGA sw rev 7\
Protocol ver 1.0

5.3.2 The “info” command

This command reports the entire state of the card. An example:

xxxxChannel Select: automatic\
Locked PAL CVBS Ch. 1


network-electronics.com

|

14

Advertising