Nevion SL-3GHD128128-RC - Manual (Page 11)

SL-3GHD128128-RC Rev. A
nevion.com | 11
2.5.1 Power Supply pinout
The DSUB 2V2P power pinout for Sublime routers and Control Panels are as follows;
Pin # Description
Socket +48VDC
Pin GND
There is a switch on the right hand side of the power supply module that selects
mains voltage. The mains voltage can be either 110VAC or 230VAC. This
switch must be set in the correct position, depending on the mains voltage on
the rou
ter’s site.
Failing to select correct AC mains voltage properly may damage the Power
Supply Unit.
2.5.2 Serial port pinout
The DE9, D-sub 9-pin female connectors for the serial port(s) of the router have the
following pin-out:
Pin # RS-232 signal
1 Not in use
2 Tx
3 Rx
4 Not in use
5 GND
6 GND
7 RTS
8 CTS
9 Do Not Connect!
Note that if the standard RS-232 cable specification (DCE) is followed:
- a cable with Male+Male or Female+Female connectors at the cable ends is
used for Rx/Tx crossed connection, and
- a cable with Male+Female connectors at the cable ends is used for a straight
through connection.