Nevion Sublime Control Panels - Manual (Page 18)

VikinX Sublime Control Panels Rev. M
nevion.com | 18
6
GPI connections
This information is only applicable on GPI versions.
The GPI / Joystick / Tally signals are connected to the Sublime Control Panel with GPI
options using DB25 male connectors. Each Sublime CP with GPI I/O has 32 GPI inputs and
32 GPI outputs available, independent of panel size.
The GPI connectors on the CP are DB25 females.
The following pin-out applies:
GPI I/O Channel # Connector pin #
1 and 17 12
2 and 18 24
3 and 19 23
4 and 20 10
5 and 21 09
6 and 22 21
7 and 23 20
8 and 24 07
9 and 25 06
10 and 26 18
11 and 27 17
12 and 28 04
13 and 29 03
14 and 30 15
15 and 31 14
16 and 32 01

Inputs are internally connected to +5V via a pull-up resistor. The inputs will be activated
when pulling them to ground. Ground is available on the following pins: 2, 5, 8, 11, 13,
16, 19, 22, 25 and on the connector chassis.

Outputs are of open collector type. An output can switch a maximum load of 100mA at
30V. Any device to be controlled by the GPI outputs (lamp, LED or similar) needs to be
connected to an external supply voltage on one end and to the GPI output on the other
end.
Warning! Do not connect external supply voltages higher than 30V DC.