Onwa Marine Electronics KP-823MKII - Manual (Page 16)

After the beginning of track record, even if it's under the pause state, move the
cursor to the "Stop", click ENT key to turn off the record. And will automatically
name the track record for the user to edit. At the beginning of track record, the
"scale ruler" on the chart screen will be a red background, otherwise be white.
Note: The status of starting, stopping or pausing the track record will be saved,
the orginal state before being shut down will be maintained.
Track record setting
Double-click the MENU key to enter the main menu, move the cursor to the
"Track" column, see Figure 22, the options for the track record method are as foll-
owing: "Mode" and "Interval". The "Mode" includes the two options: "Fill" and
"Wrap". The "Fill" modeis: When a track record is completed, the system will save
the current track and meanwhile start a new track record. The "Wrap" mode is:
When it reaches the 2100 track points for the current record, remove the track point
on the end of track line, and store the newest track point, make a cycle use of a
track's storage space.
The " " determines the span of the adjacent track points recorded, one is to
determine the span of track record by the "Time"; The other is to determine the
span of track record by the "Dist". Thus, the options for " " include:
the measurement of the record and the interval of the record. The measurement of
the record is , and the corresponding units of measurement are
" " and "nm".
The "Time" mode for the track record is as following: it takes time as the mea-
sure unit for track record interval, and records 1 track point in a specific time int-
erval. The smallest time interval is 1 second, under the recording mode of time, the
track points which change less than 0.001 points at the latitude and longitude will
not be continuously recorded.
Interval
Interval
"Time" and "Dist"
hh:mm:ss
Figure 22
14