RGBLink VSP 3550S User Manual - Manual (Page 68)

5. System Setup and Operations
How to Set the Position of Layer Image
VSP 3550 User Manual 68
How to Set the Position of Layer Image
Firstly, ensure the device is power on and in normal operation.
Operations are as follows:
1. Push any button of OUTPUT DVI1~DVI4 and LAYEY A and B, the
button blinks, and the layer can be edited.
2. Push [POS] button, key lights, and start the position setting function.
3. Turn the knob, or push the number button to input the number directly,
push the knob to confirm. OLED shows as follows:
4. Push [POS] button again, key light is off, and exit the position setting
function.
— >POS X 0
POS Y 0
RESET