C. upgrading software, Main board mcu program upgrading steps, Upgrading software – RGBLink VSP 3500 User Manual User Manual

Page 108

Advertising
background image

VSP 3500 User Manual 108

C. Upgrading Software

Main board MCU program upgrading steps

Decompression and install upgrade file:

Install USB upgrade file: find

in Dfuse, and install to the system default directory.

You also can choose by yourselves. ( You can install

DfuSe_Demo_V3.0.2_Setup.exe if the computer system is 32 bit

system, and you can install DfuSe_Demo_V3.0.2_Setup_amd64.exe if

the computer system is 64 bit system）.

Using USB interface upgrade methods: connect USB interface and

computer interface by USB line, as shown in figure:

Upgrade the two dial switch next to the LAN port::

Advertising
See also other documents in the category RGBLink Equipment: