Scotsman CME865W - Manual (Page 2)

SPECIFICATIONS
Before beginning installation, be sure that all of the
components necessary for complete assembly of
the ice system are available, and are the correct
components with regard to model, voltage, and
finish.
A stacking kit (KSCMS) is required for stacking
CME1002 or CME865 ice machines. It
interconnects the sonar bin ice level controls. A
CME865 or CME1002 may only be stacked onto
models CME865, CME1002, MCM1062 or
CMS1002.
The CME865 or CME1002 will fit any current 30"
wide Scotsman bin, such as the BH550 or
HTB555, without needing a bin top. Other bins will
require a bin top.
Note: The sonar transducer, located in the base of
the machine, must NOT be covered by installation
material (such as a non-Scotsman bin top). The
transducer must have clear access to the ice to be
able to sense the ice level.
Model Number Dimensions
W" x D" x H" Basic Electrical Minimum
Circuit
Ampacity
Maximum
Fuse Size Refrigerant
Charge*
R-404A
CME865WE-32A 30 x 24 x 27 208-230/60/1 14.5 20 36 ounces
CME865WE-6A 30 x 24 x 27 30/50/1 36 ounces
CME1002WE-32A 30 x 24 x 27 208-230/60/1 18.5 20 38 ounces
CME1002WE-3A 30 x 24 x 27 208-230/60/3 12.3 15 38 ounces
CME1002WE-6A 30 x 24 x 27 30/50/1 38 ounces
* The system charge is in the machine. This number is for recharging purposes only. If the nameplate has a
different value, go by the nameplate.
Air Temperature Water Temperature Voltage
Minimum 50
0
F. 40
0
F. -5%
Maximum 100
0
F. 100
0
F. +10%
CME865W & CME1002W
December, 1994
Page 2