For the electrician: electrical connections – Scotsman CME865W User Manual

Page 8

Advertising
background image

FOR THE ELECTRICIAN: Electrical Connections

See the NAMEPLATE for current requirements to
determine wire size to be used for electrical
hookup. The cuber requires a solid chassis to
chassis earth ground wire. See Wiring Diagram.

Be certain the cuber is connected to its own
electrical circuit and individually fused. Voltage
variation should not exceed ten percent of the
nameplate rating, even under starting conditions.
Low voltages can cause erratic operation and may
be responsible for serious damage to the
icemaker.

Electrical connections are made at the rear of the
icemaker, inside the junction box.

All external wiring should conform to the
national, state and local electrical code
requirements. Usually an electrical permit and
services of a licensed electrician will be
required.

ELECTRICAL JUNCTION BOX

FUSES or HACR

CIRCUIT BREAKERS

CME865W & CME1002W

December, 1994

Page 8

Advertising
This manual is related to the following products: