Scotsman CME865W - Manual (Page 6)

FOR THE INSTALLER: Machine & Bin Assembly
Overview:
This ice system is comprised of 2 major
assemblies:
1. The ice storage bin.
2. The ice maker itself.
Storage Bin:
After uncrating the ice storage bin, attach the legs
to the bin:
1. Use a portion of the carton as a cushion, and tip
the storage bin on its back.
2. Screw the legs into the threaded holes in the
bottom of the bin.
3. Turn the leg levelers all the way in to prepare
the bin and ice machine for leveling.
4. Return the bin to the upright position.
Ice Maker:
1. Arrange for proper electric, water and drain.
See instructions for the plumber and for the
electrician.
2. Position the ice storage bin in the selected
INDOOR location.
3. Level the bin, in both the front to rear and side
to side directions.
4. Inspect the bin top mounting gasket which
should be flat, with no wrinkles, to provide a good
water seal when the cuber is installed on top of
the bin.
5. Install the modular cuber on top of the bin using
care to be sure a good seal is made between the
two cabinets, use of a mechanical lift is
recommended. Align the holes in the bottom back
of the cabinet to mate with the two mounting straps
on the top rear of the bin.
6. Use bolts and straps found in the hardware
package to secure the ice machine to the ice
storage bin. When alignment and leveling are
completed, tighten the bolts to secure the
mounting straps.
CME865W & CME1002W
December, 1994
Page 6