Scotsman MDT6N90 - Manual (Page 12)

OPERATION: Water
Water enters the machine through the 3/8" male
flare at the rear of the cabinet, goes to the water
reservoir which it enters through the float valve.
The water then goes out the bottom of the
reservoir tank to the bottom of the evaporator.
Reservoir overflow, evaporator condensation and
water in the sink are all routed to the drain. Water
cooled models have a separate water circuit for the
cooling water: it enters the fitting at the rear, goes
to the water regulating valve, then to the water
cooled condenser and down the drain.
The water dispensing station adds an additional
water circuit. When the water station sensor
detects a container in front of it, the control board
closes a circuit to an electric water valve and water
is dispensed.
MDT6N90
May 2001
Page 12
WATER LEVEL
RESERVOIR
RESERVOIR
OVERFLOW DRAIN
SINK DRAIN
WATER VALVE
BIN DRAIN
WATER
INLET
WATER SCHEMATIC
Note: The correct water level is determined when
the machine is operating. Check the water level
and compare it to the line molded into the side of
the reservoir. The water level should be between
" above and " below the line.
If needed, adjust the water level by bending the
float arm.