Scotsman MDT6N90 - Manual (Page 5)

FOR THE ELECTRICIAN
CONFORM TO ALL APPLICABLE CODES
Connect the electrical power supply for the unit to
the wires in the junction box at the rear of the
machine.
Check the nameplate (located on the back panel)
for the voltage requirements, and for the minimum
circuit ampacity. The machine requires a solid
chassis to earth ground wire.
The ice maker should be connected to its own
electrical circuit so it would be individually fused.
Voltage variation must remain within design
limitations, even under starting conditions.
All external wiring must conform to national,
state, and local electrical codes. The use of a
licensed electrician is required to
perform the electrical installation.
MDT6N90
May 2001
Page 5
POWER SUPPLY
ELECTRICAL
CONNECTION