Design Dynamics DVF-36S-N - Manual (Page 18)

www.desatech.com 120441-01A 18
Removing and Installing Inner Door
Inner door is factory installed.
1. Open outer door. Secure door in open
position to avoid accidental breakage.
2. Remove middle door by lifting from
hinges (see Figure 26). Set aside to avoid
scratches or damage.
3. Remove screws from two side trims (see
Figure 27, page 19).
4. Remove side bricks from top to bottom
by prying out of housings(see Figure 27,
page 19).
5. Remove bottom bricks, starting with
middle section (see Figure 27, page 19).
6. Remove screen and rod (see Figure 27,
page 19).
FirePLAce inStALLAtiOn
Continued
7. While holding inner door, release 6 latches,
3 top and 3 bottom (see Figure 28, page
19).
8. Slowly tilt open glass at a 30° angle and lift
up to release glass from bottom retainer
(see Figure 28, page 19).
9. Follow these instructions in reverse to
reinstall.
LOCK
UNLOCK
Figure 26 - Removing/Installing Middle Door
Spring
Loaded Pin
Hook Located
on Inner Door
Pin Located on
Middle Door
Hinge
Middle
Door
Inner
Door
Outer
Door