Smithco Super Star 42-00x (sn 4602 – 4660/12588 – 12627) Parts & Service Manual - Manual (Page 67)

65
Accessories
42-315 LIGHT KIT PART LIST
REF# PART# DESCRIPTION QUANTITY
1 42-317 Front Light 1
2 HSTP-14-20-075 Phillips Machine Screw 1 /
4
- 20 x 3 /
4
2
HNFL-14-20 Flange Whiz Lock Nut 1 /
4
- 20 2
3 42-323 Front Light Mount 1
4 HB-516-18-100 Bolt 5 /
16
- 18 x 1 (2 WD Only) 1
HW-516 Washer 5 /
16 (2 WD Only) 1
HWL-516 Lockwasher 5 /
16 (2 WD Only) 1
FRONT LIGHT INSTALLATION
SUPER STAR 3 WHEEL DRIVE FRONT LIGHT INSTALLATION
1. Remove bolt and strong back from hose clamp on front of front fork. Place front light mount (Ref 3) on
hose clamp and replace bolt and strong back.
2. Bolt front light (Ref 1) to front light mount, using the 1 /
4
- 20 machine screws and whiz lock nuts. Be sure
wires aremacup.
SUPER STAR 2 WHEEL DRIVE FRONT LIGHT INSTALLATION
1. You will have to drill and tap a 5 /
16
- 18 hole in the front fork approximately 1" from the end, and centered,
where the steering shaft is welded.
2. Bolt front light mount (Ref 3) to the front fork using the 5 /
16
-18 bolt, lockwasher and washer (Ref 4).
3. Bolt front light (Ref 1) to front light mount, using the 1 /
4
- 20 machine screws and whiz lock nuts. Be sure
wires are up.
REAR LIGHT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 HST-516-18-075 Truss Head Screw 5 /
16
-18 x 3 /
4
4
HNFL-516-18 Flange Whiz Lock Nut 5 /
16
- 18 4
2 42-322 Rear Light Mount 1
3 42-316 Rear Light 1
HSTP-14-20-075 Phillips Machine Screw 1 /
4
-20 x 3 /
4
2
HNFL-14-20 Flange Whiz Lock Nut 1 /
4
- 20 2
REAR LIGHT INSTALLATION
NOTE: If your machine has a 42-210 Grader Blade, you will have to remove the blade
clips from the back of the seat panel to install rear light.
1. Install rear light mount (Ref 2) on back of seat panel. If you have the blade clips, put the rear light mount
between the blade clips and the seat panel. Then use the 5 /
16
-18 truss head screws and whiz lock nuts
(Ref 1) to hold in place.
2. Install light (Ref 3) with wires up on the rear light mount using two 1 /
4
- 20 machine screws and whiz lock
nuts.
Do not touch lights. Very Hot.