Sundance SMT350 - Manual (Page 20)

Version 1.9 Page 20 of 45 SMT350 User Manual
21 D-12V0 Digital –12.0 Volts – not used on the SMT350
22 DGND Digital Ground
23 D-12V0 Digital –12.0 Volts – not used on the SM350
24 DGND Digital Ground
25 DGND Digital Ground
26 EMU0 Emulation Control 0 – not used on SMT350
27 EMU1 Emulation Control 1 – not used on SMT350
28 TMS JTAG Mode Control – not used on SMT350
29 nTRST JTAG Reset – not used on SMT350
30 TCK JTAG Test Clock – not used on SMT350
31 TDI JTAG Test Input – not used on SMT350
32 TDO JTAG Test Output – not used on SMT350
33 DGND Digital Ground
Figure 10 – Mezzanine Module Interface Power Connector and Pinout.
The following few pages describes the signals on the data connector between the
main module and the daughter card. Bank A on the connector is used for the ADC
Channels A and B. Bank C is used for the DAC channels A and B. Bank B is used for
system clock and trigger signals, ADC/DAC/Clock control signal.