Q-See QSC26404 - Manual (Page 34)

QSC26404 User’s Manual
34
In the user name list box, by default only “admin” exists. You can use
【→】
key, to move “Active Frame” to password edit box, and press
【EDIT】key to enter into
edit status. Press numeric keys to input a new password. The password is made up of
16 numbers at most. After you finish inputting password, press
【ENTER】key to exit.
Move “Active Frame” to “Verify password” edit box, input the new password. Move
“Active Frame” to “Confirm” button, and press
【ENTER】, if password and verified
password are the same, the password will be saved and take effect.
If password and verified password are not same, a warning message box will
appear, as shown in fig 5.3
Fig 5.3 Error
In this case, press
【ENTER】to return to password edit box, and input the new
password again.
5.2 Add and Delete Users
Enter into “User Management” interface.
Add User
The steps are as follows:
Step 1: Enter into “User Management” menu shown in fig 5.4
Please refer to Chapter 5.1