Q-See QSC26404 - Manual (Page 70)

QSC26404 User’s Manual
70
In the “Sequence” setup menu, first input the sequence number. The sequence is from 1 to 16.
Each sequence is made up of cruise points, and each cruise point includes a preset number, dwell
time and dwell speed. Dwell time is the time staying at that preset number. Dwell speed is the
speed that the PTZ camera is moved to that preset number.
Press “Add” button to add one cruise point.
Press “Confirm” button to save the cruise point into the sequence.
After you finish setting up the sequence number, press “StartSeq” to check the current
sequence. Press “StopSeq” button to stop checking.
You can delete cruise points in a sequence.
After you finish sequence setup, press the “Return” button to return to the “PTZ” menu. In
“PTZ” menu, press “Confirm” button to save the modifications.
Note: Please make sure the PTZ camera you are using can support the sequence function.
Cruise setup
In the “PTZ” menu, press the “Setup” button on the right side of “Cruise”, you will enter into
“Cruise” setup menu as shown in fig 5.32
Fig 5.32 Cruise setup
Press “RecCru” button, you will enter into “PTZ control” interface. You can start controlling
PTZ with direction keys, press
【ENTER】to save the operation track and return to the “Cruise”
setup menu. Press the “StartCru” button to repeat the PTZ track until you press “Stop” button.
Press “Return” button to return to the “PTZ” menu. In “PTZ” menu, press “Confirm” button
to save this cruise.
Note: Please make sure the PTZ camera you are using can support the cruise function.