Operating fireplace, Installation – Desa CGCFTP User Manual

Page 19

Advertising
background image

www.desatech.com

111044-01F

19

INSTALLATION

Continued

PRESSURE TESTING FIREPLACE GAS
CONNECTIONS
1. Open equipment shutoff valve (see Figure 27,

page 18).

2. Open main gas valve located on or near gas

meter for natural gas or open propane/LP

supply tank valve.

3. Make sure control knob of fireplace is in the

OFF position.

4. Check all joints from equipment shutoff valve

to thermostat gas valve (see Figures 28 and

29). Apply a noncorrosive leak detection fluid

to gas joints. Bubbles forming show a leak.

5. Correct all leaks at once.
6. Light fireplace (see Operating Fireplace).

Check all other internal joints for leaks.

7. Turn off fireplace (see To Turn Off Gas to

Appliance, page 20).

8. Replace front panel.

Figure 28 - Checking Gas Joints Shown

with Optional Mantel (Propane/LP Gas)

Equipment Shutoff Valve

Propane/LP
Supply
Tank

Figure 29 - Checking Gas Joints Shown

with Optional Mantel (Natural Gas)

Gas Meter

Equipment Shutoff Valve

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,

follow these instructions exactly.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not use

any phone in your building.

• Immediately call your gas supplier from

a neighborʼs phone. Follow the gas

supplierʼs instructions.

• If you cannot reach your gas supplier,

call the fire department.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. If the

knob will not push in or turn by hand, donʼt

try to repair it, call a qualified service tech-

nician or gas supplier. Force or attempted

repair may result in a fire or explosion.

D. Do not use this appliance if any part has

been under water. Immediately call a

qualified service technician to inspect the

appliance and to replace any part of the

control system and any gas control which

has been under water.

Advertising
This manual is related to the following products: