Super Systems e-TRIM - Manual (Page 5)

Super Systems Inc. Page 5 of 27 e-TRIM Operations Manual
e-TRIM Touchscreen Interface
Main Screen
NOTE: This manual was written with oxygen readings from the ambient air, not in a valid run-
time environment.
This is the main screen for the e-TRIM Touchscreen software. Once the software has booted up,
this screen will be displayed. This screen will list the Burners, along with the % Oxygen
reading, the Status of each burner, and the status of high fire or low fire. The possible
messages are:
• OK – everything (coms, burner conditions, etc.) is ok.
• **coms** - there is bad communication to the sensor board.
• Alarm Pending – there is an out of band condition, and the system is waiting for the
delay timer to expire.
• **Out of Band** - The burner is out of band. Status Disabled – The board has been
disabled.
• **Critical Alarm** - There is a critical alarm active.
• Critical Alarm Ack’d – The critical alarm is active, but the alarm has been acknowledged.
The yellow icon
signals that the burner is on high fire.