Super Systems e-TRIM - Manual (Page 8)

Super Systems Inc. Page 8 of 27 e-TRIM Operations Manual
This screen will display:
Click the Offset= button to enter the offset percentage. Click OK to save it.
This option will allow the user to enter an offset for each specific burner to match an external
calibration source such as a hand held oxygen monitor. Adjustments should only be made when
on high fire for more than 120 seconds.
To change an offset for a specific burner, select the burner from the drop-down list. The button
below the list will show the current offset. Click on this button to change the offset. The range
is -20.9% to 20.9%.
Status
The Status screen shows the addresses of the connected boards that are communicating with
the controller.