Speaker connection, Remote control unit, Remote control unit speaker connection – Teac AG-H600NT User Manual

Page 9

Advertising
background image

9

EN

G

LI

SH

Caution

< Check the impedance of your speakers. Connect speaker with an

impedance of between 4 ohms and 8 ohms.

< The red speaker terminals are + (positive) and the black speaker

terminals are _ (negative).

Generally, the + side of the speaker cable is marked to make

it distinguishable from the _ side of the cable. Connect the
marked side to the + terminal and the unmarked side to the
black _ terminal.

< The metal portions of the two separate wires should not touch

or an electrical short can occur. Shorted wires can create a fire
hazard or induce a failure in your equipment.

< Be sure to insert each plug securely. To prevent hum and noise,

avoid bundling the cables together with the AC power cord or
other cables.

How to connect:

1. Turn the terminal cap counterclockwise to loosen it. The speaker

terminal caps cannot be fully removed from the base.

2. Insert the wire into the terminal and turn the terminal cap

clockwise to securely connect it:

< Make sure none of the wire insulation is under the terminal and

only the bare, stripped wire is touching the terminal.

3. Make sure the cable is fastened firmly by pulling the cable lightly.

AG-H600NT

The provided Remote Control Unit allows the unit to be operated
from a distance.
When operating the remote control unit, point it towards the
remote sensor on the front panel of the unit.

< Even if the remote control unit is operated within the effective

range, remote control operation may be impossible if there are
any obstacles between the unit and the remote control.

< If the remote control unit is operated near other appliances which

generate infrared rays, or if other remote control devices using
infrared rays are used near the unit, it may operate incorrectly.
Conversely, the other appliances may operate incorrectly.

Battery Installation

1. Remove the battery compartment cover.

2. Insert two “AAA” (R03, UM-4) dry batteries. Make sure that the

batteries are inserted with their positive “+” and negative “_”
poles positioned correctly.

3. Close the cover.

Battery Replacement
If the distance required between the remote control unit and main
unit decreases, the batteries are exhausted. In this case replace the
batteries with new ones.
For more information about collection of batteries, please contact
your local municipality, your waste disposal service or the point of
sale where you purchased the items.

Precautions concerning batteries

< Be sure to insert the batteries with correct positive “+” and

negative “_” polarities.

< Use batteries of the same type. Never use different types of

batteries together.

< Rechargeable and non-rechargeable batteries can be used. Refer

to the precautions on their labels.

< When the remote control unit is not to be used for a long time

(more than a month), remove the batteries from the remote
control unit to prevent them from leaking.

< If the batteries leak, wipe away the liquid inside the battery

compartment and replace the batteries with new ones.

< Do not use any other batteries not specified. Do not mix new

batteries with old ones or use different types of batteries
together.

< Do not heat or disassemble batteries and never throw them in

the fire or water.

< Do not carry or store batteries with other metallic objects. The

battery may short circuit, leak or explode.

< Never recharge a battery unless it is a verified rechargeable type.

Remote Control Unit

Speaker Connection

Right Speaker

Left Speaker

Advertising