Bluetooth® (2) – Teac AI-301DA User Manual
Page 20
20
Connecting with an already paired Bluetooth device
When the input source of this unit is set to “Bluetooth” and the other Bluetooth device is
on, the Bluetooth function will be active and they will connect automatically. If they do not
connect automatically, however, you can connect them manually as shown in the following
examples with smart phones.
o
If a request for a passcode appears on the screen of the Bluetooth device, enter “0000” (four
zeros).
o
When this unit and the other Bluetooth device are connected, the Bluetooth indicator stops
blinking and stays lit.
o
When pairing or connecting with another Bluetooth device, they should be within a few
meters of each other. If they are too far apart, pairing and connection afterwards might
become impossible.
o
If the Bluetooth indicator on this unit continues to blink for 10 minutes, it will automatically
enter standby mode. To use the unit again, you must press the ¤ button to turn it on.
o
When Bluetooth input is selected for this unit, the Bluetooth device that was last con-
nected to it will automatically be connected again. If you want to connect with a different
Bluetooth device, conduct pairing with that device.
NOTE
Regardless of the connection status of this unit and the other Bluetooth device, if the
Bluetooth indicator continues blinking for a long time, restart both this unit and the other
device and then reconnect them.
Bluetooth® (2)