Teac CR-H260I - Manual (Page 23)

23
ENGLISH
p To listen to an external source connected to an
AUX IN jack, select the corresponding “AUX 1 IN” or
“AUX 2 IN” setting.
p If the source is set to USB when an iPod/iPhone/
iPad is connected to the USB port, “USB” will appear
on the display until the unit recognizes the iPod/
iPhone/iPad, then “iPod” will appear on the display.
p You can also select a source you want to listen to
by pressing the corresponding source button on
the remote control (AUX1, AUX2, TUNER, CD, iPod/
USB, SD or Bluetooth).
3
Play the source, and gradually turn the vol-
ume up to the desired level by turning the
VOLUME knob.
Automatic standby
In order to reduce power consumption, if there is no play-
back signal from the selected input source and this unit is
not operated for 30 minutes, this unit will enter standby
mode.
The unit will not enter standby mode automatically,
however, if any of the following input sources are selected.
• TUNER FM
• TUNER AM
• Bluetooth (when connected to another Bluetooth device)
p Even if Bluetooth is selected as the input source, if no
other Bluetooth device is connected to the unit (paired),
the unit will automatically enter standby mode if it is not
operated for 30 minutes.
Adjusting the tone and balance
2 1
1
Press the TONE/BAL button to cycle through
the items that can be adjusted.
BASS TREBLE BALANCE
Normal display
Continued on the next page e