Teac CR-H260I - Manual (Page 34)

34
3
Press the ENTER button.
p When you press the ENTER button, the track num-
ber that is currently blinking will be added to the
program.
Example:
To select track 2:
Press “0,” “0” and “2”, or press “2” and then press the
ENTER button.
To select track 12:
Press “0,” “1” and “2”, or press “1” and “2” and then
press the ENTER button.
To select track 123:
Press “1,” “2” and “3”, and then press the ENTER but-
ton. (3-digit numbers are only for MP3/WMA files.)
p If you enter a number that is greater than the total
number of tracks, the highest available track num-
ber will appear blinking (and can be added to the
program).
For example, if you input “999,” but the media only
contains 60 tracks, “T060,” which is the highest track
number, will appear and “060” will blink.
Programmed Playback (CD/USB/SD) (2)
4
Repeat steps
2
and
3
to program more
tracks/files.
p If you make a mistake, press the CLEAR button to
remove the last input track/file number.
p Up to 30 tracks/files can be programmed. If you
attempt to program more than 30 tracks/files,
“PROG FULL” will appear on the display.
5
When programming has been finished,
press the PLAY/PAUSE button (7/9).
Programmed playback will start.
p After playback of all the programmed tracks/files
has finished or you stop programmed playback,
you can restart programmed playback by pressing
the Play/Pause button (7/9).
p If the PROGRAM button is pressed when playback
is stopped, all program contents will be cleared.