Installation – Desa FPVF33NR User Manual
Page 16
105270-01G
For more information, visit www.desatech.com
For more information, visit www.desatech.com
16
INSTALLATION
It is very important to install the logs exactly as instructed. Do not
modify logs. Only use logs supplied with fireplace.
1.
For models VYGF33PRA and VYGF33NRA, place one-piece
log set on grate to fit as illustrated in Figure 28. For models
FPVF33PR and FPVF33NR, place one-piece log set on grate
to fit as illustrated in Figure 29. Make sure middle section at
bottom of log set is seated into "U"-shaped cutout in center of
chassis (see Figure 29).
IMPORTANT:
Make sure log does
not cover any burner ports (see Figures 30 and 31).
2.
Install fireplace screen by slipping notches of fireplace screen
over screws on front of fireplace (see Figure 32).
WARNING: You must operate this fireplace with
the fireplace screen in place. Make sure fireplace
screen is in place before running fireplace.
Figure 28 - Installing One Piece Log Set (Models VYGF33NRA &
VYGF33PRA)
Figure 30 - Installing One Piece Log Set (Top View Models
VYGF33NRA & VYGF33PRA)
Notches
Figure 32 - Installing Fireplace Screen (Model VYGF33NRA
shown)
Screws for
Mounting Screen
One Piece
Log Set
Burner Ports
INSTALLATION
Installing Logs
O
F
F
P
IL
OT
O
N
H
I
L
O
Chassis
"U"-shaped
Cutout in
Chassis
One Piece
Log Set
Burner
Middle Section at
Bottom of Log Set
Figure 29 - Installing One Piece Log Set (Models FPVF33NR &
FPVF33PR)
O
F
F
P
IL
OT
O
N
H
I
L
O
Chassis
"U"-shaped
Cutout in
Chassis
One Piece
Log Set
Burner
Middle Section
at Bottom of
Log Set
Figure 31 - Installing One Piece Log Set (Top View Models
FPVF33NR & FPVF33PR)
One Piece
Log Set
Burner Ports
CAUTION: Do not remove the data plates attached
to the heater base assembly. The data plates contain
important warranty and safety information.
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
WARNING: After installation and periodically
thereafter, check to ensure that no flame comes in
contact with any log. With the heater set to High,
check to see if flame contact any log. If so, reposition
logs according to the log installation instructions in
this manual. Flames contacting logs will create soot.
INSTALLING LOGS