Adjusting the input level, Selecting the reference clock, 4 − basic operations – Teac DV-RA1000HD User Manual
Page 28
4 − Basic operations
TASCAM DV-RA1000HD
Adjusting the input level
The input level is adjustable for all inputs (analog or
digital), regardless of the current selection.
The balance between the left and right channels of the
input may also be set.
For optimum sonic quality, it is also possible to bypass
the input level and balance circuitry.
1
Press the
INPUT LEVEL
key to bring up the input
level screen:
Figure 4.19: Input level settings
2
Use the
F3
and
F4
keys to move between the
MAIN
(input level),
BALANCE
(between left and right) and
BYPASS
sections of the display.
Use the
JOG/DATA
dial to adjust the settings,
including the bypass setting.
TIP
Use the
F1
key to reset the input level to unity
gain, and the
F2
key to center the balance set-
ting.
You can adjust the analog input level to one of
the stages in the range of –∞ through +1 dB,
and the digital input level in steps of 0. dB in the
range of –10 dB through +10 dB.
3
Press
ENTER
when finished.
NOTE
When the signal on playback or recording is at –
0.1 dBFS or over for more than one sample, the
OVER indicator on the meter lights. If a track is
normalized to –0.1 dB (for example) on a DAW be-
fore recording at unity gain on the DV-RA1000HD,
the OVER indicators may therefore light, even
though there is no clipping taking place.
You can set the meter release time and peak hold
mode in the preference screen. (See “General
preferences” on page .)
To reset the peak indication, press the
CANCEL
key while the home screen is displayed.
•
•
•
•
Selecting the reference clock
As mentioned earlier, only one clock sync source
should be available within a system.
The current clock selection is always shown on the
home display.
To select the clock source for the DV-RA1000HD:
1
Press the
MENU
key, and use the
JOG/DATA
dial
to select
SYSTEM SETUP
. Press
ENTER
.
2
Use the
JOG/DATA
dial to select
REFERENCE CLOCK
.
Press
ENTER
.
Figure 4.20: Word sync selection
3
Use the
JOG/DATA
dial to select the clock source
(
SOURCE
):
•
Internal
—the DV-RA1000HD acts as the
clock master.
•
Word
—the clock sync is received from the BNC
WORD SYNC IN
connector.
•
Digital IN
—the clock is received from the
currently selected digital audio input source.
NOTE
You cannot select
Digital IN
if the
DV-RA1000HD is playing or recording a project in
DSD mode.
4
Press
ENTER
to confirm the setting and return to
the system setup menu.