Teac DV-RA1000HD - Manual (Page 33)

5 − CD playback & recording
TASCAM DV-RA1000HD

It is possible to create linear fades in and out when
playing back.
To display the fade time screen, press for at least one
second the
FADE switch on the play page of the virtual
front panel, or the FADE key on the remote control unit.
Use the F1 and F2 cursor keys and the JOG/DATA dial
to set these values (between 0 seconds and 24 seconds).
Fade times are set independently for fade-in and fade-
out operations.
Press ENTER to confirm the fade time settings.
Figure 5.3: Setting fade times
When playback starts and fade mode is
selected, a fade-in starts.
When playback stops (with the
STOP key)
and fade mode is selected, the fade-out
starts. If the STOP key is pressed during the
fade, playback stops immediately.
•
•
Fades DVD HD
The TIMER switch besides the transport keys on the
front panel allows the DV-RA1000HD to start playback
of the loaded disc automatically when power is sup-
plied.
If the DV-RA1000HD is in ODD mode or in HDD
mode with a disc already loaded, the unit plays the proj-
ect that was open prior to the last shut down, or from
the last position if resume playback is selected. (See
“Resume playback” on page 24.)
Repeat settings (see “Repeat playback” on page 31) for
the whole disc or single track are memorized when the
power is turned off and on again, but the A-B mode and
the A and B points are not memorized.
CAUTION
When using this function, remember to shut down
the unit properly (see “Shut down” on page 1)
before turning off the power, to avoid possible data
loss.
Timer start DVD HD
Recording
The following functions are available when recording to
CD-R or CD-RW. Many are also available when record-
ing to DVD±RW or HD.
The transport keys enable you to record discs as if you
were using a standard recorder.
1 Press the RECORD key ( REC key) while the trans-
port section is stopped or playback is paused to
place the DV-RA1000HD in record ready mode.
The RECORD key and READY key indicators light
up.
The DV-RA1000HD switches monitoring mode
to input signal.
When you insert a brand new disc into the
disc tray and press the RECORD key, the
DV-RA1000HD automatically performs opti-
cal power calibration (OPC). During the cal-
ibration, the RECORD key indicator lights up
and the READY key indicator flashes. When
•
the calibration is complete, the READY key
indicator lights up and the unit enters record
ready mode.
NOTE
Optical power calibration adjusts the laser power in
accordance with the characteristics of an inserted
disc so that data can be recorded at optimum qual-
ity.
2 Press the PLAY key to start recording.
The RECORD key and PLAY key indicators light
up.
To stop recording, press the STOP key.
To mute recording (that is, recording a silent
part), press the MUTE key. Press the MUTE
key briefly to mute recording. Press the
•
•
Basic recording operation DVD±RW HD