Teac CD-200 Rev.C - Manual (Page 16)

16
TASCAM CD-200
4 − Playing back CDs
Loading a CD
To load a CD, press the OPEN/CLOSE key on the main
unit or on the remote control to open the disc tray, and put
the CD into the tray with the label facing up.
Press the
OPEN/CLOSE key again to close the disc tray.
After loading the disc, the unit reads the disc’s information
and shows on the display the total number of tracks and
total playback time if it is an audio CD and the total num-
ber of tracks in the current folder if it is a data CD.
Instead of pressing the OPEN/CLOSE key to close the disc
tray, you can press the PLAY/READY key to close the disc
tray and begin playback immediately.
CAUTION
If you open the disc tray while this unit is in use, the
following settings are lost.
• Program
• Current folder (for data CDs)
Playback
The following procedures assume that the necessary con-
nections have been completed, the unit’s power has been
turned on and a CD (audio or data) has been loaded.
Press the
PLAY/READY key on the main unit or
remote control to begin playback of a CD.
PLAY/READY key
PLAY/READY key
ª Stopping playback:
Press the STOP key on the main unit or the remote
control.
ª Pausing playback:
Press the PLAY/READY key on the main unit or the
remote control.
In this manual, unless stated otherwise, explanations are
given assuming that continuous playback mode is set. (See
“Playback modes” on page 18.)