Teac CD-200BT - Manual (Page 14)

14
TASCAM CD-200BT
3 – Preparations
Making connections
Examples of connections that can be made with a CD-200BT are shown below.
8
Precautions before making connections
• Before connecting other devices, read their operation manuals carefully and connect them properly.
• Turn the power OFF or set the power to standby for this unit and all units to be connected to it.
• Set up all the units so that they are powered from the same line. When using a power strip, for example, use a thick cable with a high
current capacity to reduce fluctuation of the power voltage.
Mixer,
Recorder,
Amplifier, or
other device
ANALOG
IN
(UNBALANCED)
Digital mixer,
Digital recorder,
Digital amplifier, or
other device
DIGITAL
IN
(OPTICAL)
DIGITAL
IN
(COAXIAL)
8 Connecting analog audio devices
Connect the analog output jacks of this unit to the input jacks
of a stereo amplifier, mixer, recorder or other device with analog
inputs.
NOTE
• Cables are not included with this unit.
• Do not bundle RCA cables with power cords or speaker
cables. Doing so could cause reduced audio quality or noise.
8 Connecting digital audio devices
Connect a digital output jack (coaxial or optical) of this unit
to the input jack of a stereo amplifier, mixer, recorder or other
device with a digital input.
NOTE
• Bluetooth audio playback signals and AUX IN input signals
can only be output from the analog jacks. They cannot be
output from the digital connectors.
• The sampling frequency of this unit’s digital output is always
44.1 kHz regardless of the playback media/file sampling
frequency.
• During playback of CD, digital output is possible when the
pitch control function is in use, but the sampling frequency
is changed by an amount equivalent to the pitch control
value. When the pitch control function is on, some devices
might not be able to accept signals from the digital outputs
of this unit.