Teac CD-200BT - Manual (Page 18)

18
TASCAM CD-200BT
4 – CD playback
Playback area
With data CDs, you can set the area to be used for playback (PLAY
AREA setting). Follow the procedures below to set the playback
area.
Setting the playback area
Press and hold the PLAY MODE/PLAY AREA [SOURCE SEL]
button on the main unit or press the remote control PLAY AREA
button to set the playback area.
The selected playback area is shown as follows in the main
display area for about two seconds and then disappears.
Depending on the selected playback area, the FOLDER
indicator might also appear on the display.
Main
display area
FOLDER
indicator
Meaning
ALL PLAY Not shown All files on the data CD will be played
back.
FOLDER Shown
All files in the selected folder on the
data CD will be played back.
Playback modes
This unit can play back tracks using the following four playback
modes.
Continuous playback mode (default setting)
Tracks on the CD are played back in numerical order.
NOTE
When
FOLDER
is the playback area for a data CD, the
tracks in the current folder will be played back in numerical
order.
Single playback mode
The selected track on the CD is played back once and then
playback stops.
Random playback mode
The tracks on the CD are played back in random order regardless
of their track numbers. Playback stops after all tracks have been
played.
NOTE
When FOLDER is the playback area for a data CD, the
tracks in the current folder will be played back in random
order. (See “Folder playback (data CDs)” on page 20.)
Program playback mode
The programmed tracks are played back in program order. See
“Programmed playback” on page 20 for details.
Selecting the playback mode
Press the main unit PLAY MODE/PLAY AREA [SOURCE SEL]
button or the remote PLAY MODE button to cycle through the
playback modes. During playback, however, you can only switch
among continuous, single and random playback modes.
To select programmed playback, press the main unit PLAY
MODE/PLAY AREA [SOURCE SEL] button or the remote PLAY
MODE button when playback is stopped.
The currently selected playback mode is shown on the display as
follows.
Indicator Playback mode
No indicator Continuous playback mode
SNGL
Single playback mode
RAND
Random playback mode
PROG
Program playback mode
The selected playback mode is retained even when the
power is turned off.
NOTE
Immediately after pressing the PLAY MODE/PLAY AREA
[SOURCE SEL] button on the main unit or the PLAY MODE
button on the remote control, the selected mode is shown
on the main display area as follows.
Continuous playback mode set:
CONTINUE
Single playback mode set:
SINGLE
Random playback mode set:
RANDOM
Programmed playback mode set:
PROGRAM