Teac CD-VT2 - Manual (Page 14)

1 TASCAM CD-VT2
IMPORTANT SAFETY PRECAUTIONS Quick Start Guide—Basic Operation
Using the Effects
To apply effects to the signal input through the mic, press the
EFFECT key to open the
EFFECTOR
screen. When the
BANK
value is highlighted as shown below, use the VALUE (+, –) keys
to select one of the effect banks (01–05).
After selecting an effect bank, select an effect preset by using
the down
CURSOR ( ¶ ) key to highlight the
PRESET
value.
Then use the VALUE (+, –) keys to select a preset. Each preset
uses a different combination of effect modules. (See the
“Effect preset list” on page 39.)
Press the right
CURSOR key ( ¥ ) to open the effect level
adjustment screen. Use the VALUE (+, –) keys to change the
level.
NOTE
You can change the parameter settings for every effect.
(For details, see “Using built-in effects” on page 31.)
Singing or playing along with a CD
You can listen to the sound from both a CD and your voice or
instrument at the same time through headphones. To change
the volume balance between the CD and the mic input, press
the
LEVEL key to open the
LEVEL
screen. Press the right
CURSOR key ( ¥ ) to highlight the
MIC 1 LEVEL
value,
then use the VALUE (+, –) keys to adjust the mic volume. (See
“Adjusting the input level” on page 30)
Turning off the power
When you stop using the player, press the POWER switch on
the back of the unit for about one second. Release the switch
when “
TRAINER SERIES
” appears on the display.
Restoring all settings to original values
If you press and hold both the µ and ≤ keys when you turn
the player power ON, the
INITIALIZE
screen appears.
After startup, follow the onscreen instructions and press the
¥/π key to restore every effect parameter, playback setting
and other adjustable setting to the values they were set at when
they unit was shipped from the factory.