Teac UH-7000 - Manual (Page 8)

8
TASCAM UH-7000
2 – Names and Functions of Parts
Rear panel
w ANALOG (BALANCED) LINE IN 1/2 jacks
These analog line inputs are standard TRS jacks. (Tip: HOT,
Ring: COLD, Sleeve: GND)
e ANALOG (BALANCED) MIC IN 1/2 jacks
These analog mic inputs are balanced XLR jacks. (1: GND, 2:
HOT, 3: COLD)
r ANALOG (BALANCED) OUTPUT L/R jacks
These analog outputs are balanced XLR jacks. (1: GND, 2:
HOT, 3: COLD)
t USB port
Use the included USB cable to connect the unit to a
computer (supports USB 2.0).
CAUTION
• USB 1.1 is not supported.
• When connected to a USB 3.0 port, it will function in High
Speed mode equivalent to USB 2.0 (480 Mbps maximum).
• This unit does not support computer suspend (sleep) mode,
so the unit might not function properly after this mode
ends. In this case, reconnect the USB cable.
y DIGITAL (AES/EBU) IN jack
This digital audio input connector supports the IEC 60958
professional (AES/EBU) and consumer (S/PDIF) standards.
u DIGITAL (AES/EBU) OUT jack
This digital audio output connector supports the IEC 60958
professional (AES/EBU) and consumer (S/PDIF) standards.
i AC IN connector
Plug the included power cord in here.