Dimmer, Analog output setting, Automatic display darkening setting – Teac GRANDIOSO D1 User Manual

Page 16: Automatic power saving setting, Setting mode (continued)

Advertising
background image

16

16

DIMMER

DIMMER>***

You can adjust the brightness of this unit's display and indicators.
By default, the setting is 3.

3 (ordinary brightness)

2

1

0

o

The dimmer of this unit can be adjusted using the DIMMER button
of a remote control included with a P1 or other Esoteric product.

o

Even when set to any value other than 3 (ordinary brightness),
ordinary brightness will be used when displaying error messages
and setting menus.

Analog output setting

AOUT>***

Use this to select the analog output connector to be used.
By default, the setting is XLR2.

RCA
An analog audio signal is output from the RCA connector.

XLR2
An analog audio signal is output from the XLR connector with pin 2
HOT.

XLR3
An analog audio signal is output from the XLR connector with pin 3
HOT.

Automatic display darkening setting

DPaOFF>***

You can set the display to darken automatically after a set amount of
time has elapsed.
By default, the setting is ON.

ON
The display will automatically darken after 30 minutes elapse without
any operation or change in the information shown.

OFF
The display will not automatically darken.

o

We recommend setting this to “ON” because brightness irregulari-
ties might occur if the same information is shown without change
on the display for a long time.

Automatic power saving setting

APS>***

The unit can be set to turn off automatically if the set amount of time
elapses without being able to lock to a digital signal from an input
source.

30m
The unit will automatically turn off if 30 minutes elapse without play-
back or other operation.

60m
The unit will automatically turn off if 60 minutes elapse without play-
back or other operation.

90m
The unit will automatically turn off if 90 minutes elapse without play-
back or other operation.

120m
The unit will automatically turn off if 120 minutes elapse without
playback or other operation.

OFF
The automatic power saving function is disabled.

Note about the automatic power saving (APS) function
This product is compliant with the European ErP directive for
standby power.
In order to comply with the above directive, the automatic
power saving (APS) function is set to 30 minutes when shipped
from the factory, so the unit will automatically turn off if 30
minutes elapse without being able to lock to a digital signal
from an input source.

Setting mode (continued)

Advertising