Teac D-07x - Manual (Page 11)

11
En
gl
is
h
Basic Operation
3 Start playback of the selected input device
and adjust the volume.
When connecting the unit directly to a power amp with-
out using a preamp in between,
use the VOLUME (−/+) buttons to adjust the volume (see page 10).
When connecting the unit to a preamp,
use the VOLUME (−/+) buttons to set the volume to 0.0 dB.
o With this unit, you can set the analog audio output (LINE OUT)
and headphones output levels independently.
o Audio is output through either the analog output (LINE OUT)
jacks or the headphones (PHONES) jack.
Audio will not be output from the LINE OUT jacks if headphones
are connected to the PHONES jack.
o The remote control included with another Esoteric product can
be used to change the input, adjust the VOLUME (−/+) and for
MUTING (see page 7).
o Press the POWER button to turn off the unit after use.
o When powering off your audio system, always make sure to turn
off the power amplifier first.
1 Press the POWER button to turn the unit on.
The ring around the POWER button lights blue.
o When connecting a power amplifier to the unit, make sure to
turn the amplifier on after turning on other devices.
o Also turn on all devices connected to the unit.
o When CLK (clock) is set to IN or DMCK, if a clock signal cannot be
detected as soon as the unit is turned on, “WRD UNLCK!” or “NO
WORD” might appear on the display, but these messages will
vanish if an input clock signal is locked after a connected device
is turned on.
2 Press the INPUT button to select an input.
Each press of the button changes input and the selected input
appears on the display as follows:
XLR
z
RCA1
z
RCA2
z
OPT
z
USB
Play back the source after selecting the source.
The text on the display flashes when a digital signal is not
detected. Turn on the connected device and check connections.
o When connecting the unit directly to a power amp without using
a preamp in between, minimize the volume (---) before changing
the input device.