Tendzone TYCHO T 1212/CA - Manual (Page 12)

address of video camera, and the protocol is related with the camera model;
Finally, the preset point number is the mark defined by the user for the video camera. Then adjust the upper, lower, left,
right, focal length, light ring and other parameters, to define the position and settings of the video camera;
Note: a video camera can contain multiple preset points, but a preset point can only correspond to a video camera
address.
Finally, click "save" to save the parameters on the video camera. "Clear" is to delete the information of the current preset
point, and "call" is used to view the video camera position saved in the current preset point.
C. The number of MIC generally corresponds with the input channel, i.e. the number of channel connected to the MIC.
The one with # indicates that the MIC number is the virtual number, which can only be used in setting default MIC.
The smaller the priority number is, the higher the priority level is. When the priority levels are the same, it shall be
handled in accordance with the triggering priority; for example, if speech is made via two MICs, the video camera will
automatically turns to the corresponding preset position of the MIC with smaller priority number (i.e. higher priority level)
or send the corresponding command to the MIC with smaller priority number (i.e. higher priority level). The one of which
the signal is first checked shall prevail.
To enable the MIC setting is when there are multiple MICs, all MIC parameters can be preset. During the actual use, only a
few are enabled in accordance with the actual situation.
The preset point, serial port number, video camera address and protocol are generally related with the video camera, and
must be corresponding to the actual connection of the video camera.
The custom command is to send the corresponding command to the defined serial port when the matrix MIC checks the
input signal (usually when someone is speaking). Secondly, the command can be preset, but the "enable the custom
command" shall not selected. Then the equipment will not automatically send the command, but one can still press the
"send" button, to send the command in the input frame to the specified serial port at any time.
Note: both the video camera settings and the MIC settings have the preset point, serial port number, video camera address,
protocol and other parameters, which shall be in accordance with the actual occasion in practical use.
For example, a video camera shall be connected with the audio processor at Port 232, and shall be disconnected and then
connected with another audio processor at Port 485 without changing the position after debugging. At this moment, the
parameters in the video camera shall be remained and not required to be reset. It is only required to adjust the MIC
settings. However, Port 485 shall be chosen at this moment.
Click "save" to save the parameter information on the device. At this moment, the channel MIC has been associated with
the corresponding video camera address. Determine whether the MIC setting is effective when enabling tracking through