Teo 8610 ISDN Phone Installation - Manual (Page 20)

Tone Commander 8610/8620 Installation Instructions
Page 20 13-280116 Rev. C
SPID Entry __________________________________________________
A unique SPID (Service Profile IDentifier) is required for operation of the 8610/8620. If the network
supports AutoSPID, a SPID that is assigned to your ISDN line can be automatically selected. If National
ISDN generic SPID assignments are used by your service provider, your SPID will consist of your primary
telephone number followed by “0101” (e.g., 42534910000101). Contact your network service provider for
your telephone’s SPID.
From the Installation Options menu, select SPID.
(
SETUP
→ INSTL → SPID)
Using the dial pad, enter the SPID number supplied by your network service provider.
If you need to make corrections, select
ÅBKSP (backspace) to delete the previous digit.
CLEAR removes all digits, allowing you to start over.
When digits have been entered, press the DONE key to return to the Installation Options menu or
press the SETUP key to exit Setup Mode.
Parameter Download _________________________________________
(National ISDN only)
ISDN Parameter Download is an automated feature for configuring Call Appearance and Feature Activator
keys. If configured for auto download, a Parameter Download is executed when the phone initializes with a
new SPID, or when requested by the network, due to a line configuration change.
Note: Speed Dial and DSS keys are not configured by Parameter Download.
From the Installation Options menu, select PARAM.
(
SETUP
→ INSTL → PARAM)
Starting a Download
Select START to manually initiate a Parameter Download.
Enabling/Disabling Automatic Download
Select AUTO.
Select ENABLE or DISABLE.
ID=42534910000101
←BKSP CLEAR
PARAMETER DOWNLOAD
START AUTO
AUTO DOWNLOAD=ENABLED
ENABLE DISABLE