Thinklogical StudioPRO Extender Manual - Manual (Page 12)

®
S t u d i o P R O E x t e n d e r P r o d u c t M a n u a l , R e v . D , O c t o b e r , 2 0 1 3 Page 11
3.6 Order of Installation Events
Refer to the SPE Quick Start Guides included in Appendix C on pages 23-26 for detailed installation
instructions.
3.6.1 Fiber Optic Cables
Fiber Optic cables for the SPE system are not included but are available commercially or through
Thinklogical
® . Please contact your Thinklogical ® sales representative for a quotation on your required
cable length or call us at 1-800-291-3211.
Two to three fiber optic cables must be run between the location of the SPE Transmitter (at the CPU or
other DVI-D video source) and the SPE Receiver (monitor, projector, etc.). The standard multi-mode
fiber cable must be 50 micron, terminated with an LC, SC, or ST-type connector. Single-mode fiber optic
cables with SC-, ST- or LC-type connectors (UPC polish) are available.
Be careful to not kink or pinch the fiber cable as it is being installed and keep all bend radii to no less
than 3 inches. Connect your fiber cables (L1Tx to L1Rx, L2Tx to L2Rx, etc.) to the fiber connectors on
each pair of SPE Transmitters and Receivers and dress the cable to prevent crushing, pinching or other
damage.
Fiber Optic Cable with LC-Type connectors
3.6.2 Digital Video Interface (DVI-D) Input – Transmitter
The SPE Transmitter connects to your DVI video source (DVI-D video card) using the provided DVI-D
male-to-male cable. The Digital Video Interface connector on the transmitter will not accept other
DVI connectors such as DVI-I or DVI-A.
DVI-D (Digital Video Interface) Connector
3.6.3 Digital Video Interface (DVI-D) Output - Receiver
The SPE Receiver unit connects to your DVI-D video monitor, projector, or other viewing device at the
remote destination. Your device must have a DVI-D connector.
3.6.4 USB Type B – Transmitter
Connect your PC’s USB-A port to the Transmitter’s USB-B port using the provided USB A to B Cable
(CBL000015-006FR). The USB-B port is located on the rear panel of the Transmitter unit.
USB Type B port and connector