Thinklogical Velocityrgb System-9, 10 and 12 Manual User Manual

Page 18

Advertising
background image


Revision D

13

December 2012

Some menu options may not be available on some models

Display

Modifiable

Description

*System

LS Connected

NO

An indication of the fiber status from the TX to RX.

TX Ctrl Name

TX Only

Name entered on TX unit is displayed on RX unit.

Load Defaults

YES

Loads factory default video configurations.

Store Values

YES

Store video configurations.

TX Control

NO

Revision of the TX control firmware.

RX Control

NO

Revision of the RX control firmware.

FPGA Version

NO

Revision of the FPGA code

Serial Number

YES

Serial Number of unit.

Aud Reset En

YES

Resets the audio sync circuitry

SFP Loss of Signal

NO

An indication of fiber status on the extender Receive

channel. Value =

0 if signal is received, 1 if signal is missing.

Debug Values

YES

Factory Use Only.

___________________________________________________________________________________________
______________

*DDC – To be implemented at a later date

DDC PROM Emula. Mode

YES

Options are Dynamic, Static and Passthru.

In Dynamic mode, the DDC of the monitor connected to the RX is
read and stored on the TX. The CPU is informed of a change in
DDC and the monitor is read. This is useful when the CPU can be
turned on without a connection to the RX. Static mode is used to
maintain the current DDC regardless of monitor changes at the
RX. Pass-thru acts as a wire between the TX and RX and no
emulation takes place.

Load Default DDC

YES

Loads the default EDID table into the TX and changes the

mode to

Static.

Acquire DDC

YES

Gets the EDID table from the monitor attached to the RX and

stores it

in the TX.

Force DDC mode

YES

Sets the EDID Video Input Signal Type to either analog or

digital.


* Video

VGA Connected

No

An indication of whether VGA video is input to the Vis TX

Resolution input

No

Active pixels x active lines vertical rate

Hor. Freq

No

Horizontal frequency

Auto Phase

Yes

Automatically adjust the Sampling Phase to the best setting

PLL Total

Yes

The total pixel count in one line. Consists of Horizontal active

pixels +

Horizontal blanking pixels

HSOUT Width

Yes

Horizontal sync (Hsync) of video, measured in pixels

DE Start

Yes

Horizontal back porch (Hpb) of video, measured in pixels

DE Width

Yes

Total active pixels in one line

Line Start

Yes

Vertical back porch (Vbp) + Vertical sync (Vsync) of video,

measured

in lines

Advertising