Thinklogical Velocityrgb System-9, 10 and 12 Manual - Manual (Page 22)

Revision D 17 December 2012
Follow the steps in Section 4.3.2 Saving Changes to save your changes.
4.2.4 Naming the Transmitter Unit
Modify the name of the unit through the Transmitter. The name entered on the Transmitter will
display on the Receiver unit.
Using the arrow down button, scroll down to *System as shown below.
Using the right arrow, scroll right until Tx Ctrl is displayed as shown below. Then press enter.
*System
Tx Ctrl
Name=
TXUnit01
Load Defaults
Yes/No=
YES