Tri Tool 204B Flange Facer - Manual (Page 12)

12
TRI TOOL INC.
92-0698 : Orig. 970131
Damaged or worn tool bits are evident by increased feed pressure, visual
observations, poor surface finish, etc.
Replace as required.
POSITIONING OF THE TOOL HOLDER
Turn the feed sprocket clockwise to feed the tool holder in.
Tool holder feed travel is from O.D. to I.D.
ADJUSTMENT OF THE TOOL HOLDER
Loosen the hold-down screws on the adjustable slide rail.
Run the tool holder to the most outward position.
Using the adjustment set screws, apply a light force to the side of the adjustable slide
rail so that it is in positive contact with the tool holder.
Adjust only those screws which bear directly in line with the tool holder.
Tighten the hold down screws to about 12 to 24 in-lbs. (Finger tight using a hex key).