Tri Tool 204B Flange Facer User Manual
Page 13
13
Model 204B-FF Flange Facer
92-0698 : Orig. 970131
Using the 1/4” drive ratchet, run the tool holder to the inward most position.
Note any changes in the feed pressure.
Some drag from the slide rails should be felt, but only a very light torque should be
required to move the tool holder.
Adjust the remaining adjustment set screws so that the tool holder has a smooth, even
feel.
Run the tool holder the full length of the slide rail.
Tightly lock the adjustable slide rail in place with the hold-down screws and fully snug
the adjustment set screws.
Check that the tool holder runs smoothly and evenly for the full length of travel.
Re-adjust as necessary.
ADJUSTING THE DEPTH OF CUT
Rotate the feed knob on the Model 204B until the desired position is achieved.
Depth of the cut for roughing should not exceed .030”.
Finish cut for optimum finishes should be .005” to .015”.
Lock the mandrel in place by tightening the torque acceptance keys to the mandrel
shaft.