Maintenance – Tri Tool 204B Flange Facer User Manual
Page 9
9
Model 204B-FF Flange Facer
92-0698 : Orig. 970131
NOTE:
MAINTENANCE
IN GENERAL
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter or oil which is
specified for the air motor.
If the Model 204B BEVELMASTER
TM
with the Model 204B-FF Flange Facer is
operated in the vertical position (cutting head up), the chips and/other debris should be
removed after each pass has been completed.
Tool life may be severely shortened, unless chips and/or other debris that have
been deposited on the cutting head during the machining operation are
removed.
DAILY MAINTENANCE
Visually inspect all parts for damage due to chips, impact or improper use.
Repair or replace broken or damaged parts as necessary.
Wipe the machine clean of cutting fluids, dirt and grime and then coat it with a light film
of oil.