Tri Tool 204B Flange Facer - Manual (Page 14)

14
TRI TOOL INC.
92-0698 : Orig. 970131
WARNING:
FEED RATE
The feed rate is .013” per revolution per tripper shaft.
INSTALLATION OF THE TOOL BITS
To select the appropriate tool bits, refer to the tool bit selection chart.
Use of dull or improperly designed Tool Bits or Tool Bits not manufactured by
TRI TOOL Inc. may result in poor performance and may constitute abuse of this
machine and therefore voids the TRI TOOL Inc. factory warranty.
Slide the tool bit into the tool bit holder slot on the tool holder.
Lock the tool bit into position with the set screws on the side of the tool holder.