Installation – Desa VF-30N-PJD User Manual

Page 8

Advertising
background image

www.desatech.com

111826-04C

8

INSTALLATION

NOTICE: This heater is intended

for use as supplemental heat.

Use this heater along with your

primary heating system. Do not

install this heater as your pri-

mary heat source. If you have a

central heating system, you may

run system’s circulating blower

while using heater. This will help

circulate the heat throughout the

house. In the event of a power

outage, you can use this heater

as your primary heat source.

WARNING: A qualified ser-

vice person must install heater.

Follow all local codes.

WARNING: Before installing in

a solid fuel burning fireplace, the

chimney flue and firebox must be

cleaned of soot, creosote, ashes

and loose paint by a qualified chim-

ney cleaner. Creosote will ignite

if highly heated. A dirty chimney

flue may create and distribute soot

within the house. Inspect chimney

and firebox flue for damage. If

damaged, repair flue and firebox

before operating heater.

WARNING: Seal any fresh

air vents or ash clean-out doors

located on floor or wall of fire-

place. If not, drafting may cause

pilot outage or sooting. Use a

heat-resistant sealant. Do not

seal chimney flue damper.

WARNING: Never install the

heater

• in a bedroom or bathroom

• in a recreational vehicle

• where curtains, furniture, cloth-

ing or other flammable objects

are less than 42 inches from the

front, top or sides of the heater

• in high traffic areas

• in windy or drafty areas

CAUTION: This heater cre-

ates warm air currents. These

currents move heat to wall sur-

faces next to heater. Installing

heater next to vinyl or cloth wall

coverings or operating heater

where impurities (such as, but

not limited to, tobacco smoke,

aromatic candles, cleaning flu-

ids, oil or kerosene lamps, etc.) in

the air exist, may discolor walls

or cause odors.

IMPORTANT:

Vent-free heaters add moisture to

the air. Although this is beneficial, installing heater

in rooms without enough ventilation air may cause

mildew to form from too much moisture. See Air

for Combustion and Ventilation, page 5.

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP)

for your unit. If your gas supply is not correct, do

not install heater. Call dealer where you bought

heater for proper type heater.

WARNING: This appliance

is equipped for (natural or pro-

pane/LP) gas. Field conversion

is not permitted.

Advertising